Set Interface - Avaya G450 Cli Reference Manual

User Level
read-write
Context
sls > ds1
sls > bri
Example
To specify the ISDN Layer-3 country protocol type as Australia:
G450-001 (sls-ds1-<port address>)# set country-protocol 2
Related DS1 commands
clear ds1, set bearer-capability,
set interface-companding,
signaling-mode,
Related BRI commands
bri, clear bri, set
endpoint-init, set
spid-a, set spid-b,

set interface

Use the set interface command to specify the glare-handling convention for a DS1 or BRI
link in SLS. This command also determines the polarity of the ISDN Layer 2 (LAPD) protocol
operation.
Note:
For a DS1 circuit, this command specifies the glare-handling convention for the
Note:
set connect
DS1 link.
Note:
This command is only valid for a DS1 or BRI circuit.
Note:
Syntax
set interface glare-mode
set bit-rate,
set long-timer,
set sls, show (ds1), show
bearer-capability, set
interface, set interface-companding,
set sls, set tei-assignment,
command that has been administered as pbx at the far-end of the
set channel-numbering,
set name, set protocol-version,
ds1, show sls, sls
directory-number-a, set
set layer1-stable,
show bri, show
SLS survivability
set connect, set
set side, set
directory-number-b, set
set name, set
(bri), show sls, sls
Issue 1 January 2008
interface,
side, set
969