Ip-Protocol - Avaya G450 Cli Reference Manual

Related Commands - Policy
composite-operation, cookie, destination-ip,
policy-based routing, packet
show isdn bri link,
destination-port,
Related Commands - VPN
description (ip rule), destination-ip,
ip crypto-list, ip-protocol,
crypto-list, tcp destination-port,

ip-protocol

Use the ip-protocol command to specify that the current rule applies to packets having the
specified IP protocol.
Use the no form of the command to set the IP protocol to its default value.
Use the not form of this command to specify that the current rule applies to all packets except
those having the specified IP protocol.
Syntax
[not] ip-protocol protocol_name | protocol_number
no ip-protocol
Parameters
Parameter
protocol_name
protocol_number
User Level
read-write
Context
ip access-control-list/ip-rule, ip capture-list/ip-rule, ip pbr-list/ip-rule, ip qos-list/ip-rule,
crypto-list/ip-rule
Note:
The not form of the command is not relevant in the crypto-list/ip-rule context.
Note:
sniffing), owner,
show list, source-ip, tcp
udp source-port
dscp (policy-based routing, packet sniffing,
ip-rule (VPN), local-address,
tcp source-port,
Description
Name of the IP protocol to match
Number of the IP protocol to match
dscp (policy), dscp-table, icmp,
show composite-operation,
destination-port, tcp established,
protect crypto
udp destination-port,
Packet sniffing
ip-rule (policy,
show dscp-table,
tcp source-port,
VPN), fragment,
map, source-ip, show ip
udp source-port
Possible Default
Values Value
1-255
Issue 1 January 2008
udp
657