Set Channel-Numbering - Avaya G450 Cli Reference Manual

CLI Commands

set channel-numbering

Use the set channel-numbering command to select the channel-numbering method for
B-channels on an E1 interface in SLS.
Note:
This command is only valid for DS1.
Note:
Syntax
set channel-numbering method
Parameters
Parameter
method
User Level
read-write
Context
sls > ds1
Example
To select the channel-numbering method for B-channels to seq:
G450-001 (sls-ds1-<port address>)# set channel-numbering seq
Related Commands
clear ds1, set
interface-companding,
signaling-mode,
966 Avaya G450 CLI Reference
Description
The channel-numbering method for B-channels on an
E1 interface:
seq – Sequential codes of B-channels 1-30 in
●
the ISDN Channel Identification IE
tslot – Timeslot method
●
bearer-capability, set
set long-timer,
set sls, show (ds1),
bit-rate, set connect, set
set name, set protocol-version,
show ds1, show sls,
SLS survivability
Possible
Values
seq
tslot
country-protocol, set
set side, set
sls
Default
Value
tslot
interface, set