Show Ip Ospf - Avaya G450 Cli Reference Manual

CLI Commands
Example
To set the SPF delay time to 5 seconds:
G450-001(router:ospf)# timers spf 5
Related Commands
area, default-metric

show ip ospf

Use the show ip ospf command to display general information about OSPF routing.
Syntax
show ip ospf
User Level
read-only
Context
general
Example
To display IP OSPF routing information:
G450-001(super)# show ip ospf
Routing Process OSPF with ID 149.49.75.71
Number of areas in this router is 1
Area 0.0.0.0
Number of Interfaces in this area 0
SPF algorithm executed 1 times
SPF hold time is 3 sec
Related Commands
ip ospf authentication,
hello-interval, ip ospf
ospf router-id,
show ip protocols
630 Avaya G450 CLI Reference
(OSPF), network
ip ospf authentication-key,
message-digest-key,
router ospf, show ip ospf
(OSPF), passive-interface,
ip ospf cost,
ip ospf network point-to-multipoint,
database, show ip ospf
redistribute (OSPF)
ip ospf dead-interval,
ip ospf
interface, show ip ospf
OSPF
ip ospf
priority, ip
neighbor,