Avaya G450 Cli Reference Manual page 1033

Parameters
Parameter Description
The required trunk group number
tgnum
The trunk group type. This
group-type
argument is required to enter the
trunk-group context.
See the following for capacities by
group type:
●
You can create a trunk group that does not have any assigned members. Once a valid port is
assigned as a trunk group member, this trunk group becomes active and may be employed by
SLS call processing for incoming/outgoing trunk operation. The slot-configuration table will be
used together with the port capacity for the given module to determine the validity of a port
assignment at administration time.
As a corollary to this, there may not be more active trunk groups than there are physical trunk
members within a given gateway. Secondly, a combo-port may only be used for one active
assignment. For example, the analog station/DID trunk ports may be either allocated to serve as
an analog station or as an analog DID trunk, but not BOTH.
The maximum limits for a given trunk type are defined by the slot-configuration assignment for
the G450. The maximum number of ports allowed per interface module is defined in
for the G450.
Table 113: G450 SLS group type assignments
Group type Media module
loop-start MM711
ground-start
did
G450: Table 113
Number of
ports/channels
Ports 1-8
Possible Values
1-2000
loop-start (analog)
did (analog)
ground-start (analog)
bri (ISDN basic rate)
t1isdn (ISDN primary rate
on 1.544 Mbps facility)
e1isdn (ISDN primary rate
on 2.048 Mbps facility)
t1inband (non-ISDN rate
on 1.544 Mbps facility)
e1inband (non-ISDN rate
on 2.048 Mbps facility)
Description of trunks that may be
assigned
Issue 1 January 2008
SLS survivability
Default
Value
Table 113
1 of 2
1033