Show Port Edge State - Avaya G450 Cli Reference Manual

Related Commands
set port spantree,
spantree priority,
forward-delay,
tx-hold-count, show spantree

show port edge state

Use the show port edge state command to display the edge state of the specified port. If
no port is specified, information for all ports is displayed.
Syntax
show port edge state [module/[port]]
Parameters
Parameter
module
port
User Level
read-only
Context
general
Example
To show edge state for all ports:
G450-001(super)# show port edge state
Related Commands
set port auto-negotiation-flowcontrol-advertisement,
set port edge admin
name, set port
auto-negotiation-flowcontrol-advertisement,
set port spantree cost,
set spantree default-path-cost,
set spantree hello-time,
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 10/5-6 for
both ETH LAN ports 5-6 on the front panel.
state, set port enable |
negotiation, set port point-to-point admin
set port spantree force-protocol-migration,
set spantree enable |
set spantree max-age,
set port enable |
disable, set port
status,
show port flowcontrol
disable, set spantree
set spantree priority,
Possible Default
Values Value
disable, set port
flowcontrol, set port level,
set port speed, show port
Issue 1 January 2008
Spanning tree
set port
set spantree
duplex,
set port
1111