Download Print this page
Avaya G450 Installing

Avaya G450 Installing

The upgrade memory kit
Hide thumbs Also See for G450:

Advertisement

Quick Links

Installing the upgrade memory kit in the
G450 and G430 Media Gateway
Important:
Always check the Avaya Support Website for Product Support Notices at
support
and select Communication Manager > Product Support Notices.
This Job Aid describes the steps required to install the upgrade memory kit components in the
Avaya G450 and Avaya G430 media gateways.
The upgrade memory kit enables increasing the number of announcement files on the gateway from
256 to 1024, by storing them on a removable compact flash. This also increases the total amount of
announcement time from 45 minutes to four hours. Since the announcements are played from RAM,
you must also increase RAM. The upgrade memory kit consists of:
• 1 GB compact flash memory card
• One RAM card. Use the RAM card applicable to your gateway, as detailed below
Related links
Equipment ordering
Equipment ordering
When ordering the upgrade memory kit, quote the relevant comcodes from the following:
Upgrade memory kit versions
1.x
2.x and 3.x
Related links
Installing the upgrade memory kit in the G450 / G430 Media Gateway
©
2014-2018, Avaya, Inc.
All Rights Reserved.
on page 1
http://www.avaya.com/
Comcode
700510107
700476419
on page 1
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the G450 and is the answer not in the manual?

Questions and answers

Summary of Contents for Avaya G450

  • Page 1 When ordering the upgrade memory kit, quote the relevant comcodes from the following: Upgrade memory kit versions Comcode 700510107 2.x and 3.x 700476419 Related links Installing the upgrade memory kit in the G450 / G430 Media Gateway on page 1 © 2014-2018, Avaya, Inc. All Rights Reserved.
  • Page 2 The G450 has two RAM slots. The basic configuration includes one 256 MB RAM card. The slots are located on the G450 main board. You must pull out the main board to remove or insert a memory card. The G450 supports hot insertion and removal of the main board without power drop.
  • Page 3: About This Task

    512 MB RAM card from the kit into this slot and push down, until the two latches on either side of the card lock into place. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...
  • Page 4 1. Locate the RAM slot holding the RAM card, as shown in the figure. 2. Open the latches on both sides of the RAM slot. The RAM card lifts up. 3. Pull out the 256 RAM card. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...
  • Page 5 3. Push the main board in until the latches begin to close. 4. Close the latches. 5. Close and tighten the two captive screws on the front panel. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...
  • Page 6 Serial Number : UNKNOWN Manufacture Part Num : UNKNOWN Faults • A G450 2.x and greater with increased memory displays, for example: MEMORY SOCKET #1 ------------------ Type : 512MB DDR SDRAM memory module Serial Number : 0550749f Manufacture Part Num : 9VDDT3272AY-335G4...
  • Page 7 Remove four screws from the right side. 1 — 4 Four G430 right-side cover screws. c. Remove three screws from the left side. See third figure below. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...
  • Page 8 Do not use too much force. 5. Flatten the RAM card so it is flush with the main board. The latches at both sides click shut. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...
  • Page 9 • Three screws on the left side as shown in the following figure. 1 — 3 Three G430 left-side cover screws. 3. Attach the mounting brackets to the G430, if applicable. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...
  • Page 10: Inserting A Compact Flash Memory Card

    : No Fault Messages Inserting or removing a compact flash memory card The G450 and G430 support hot insertion and removal of a compact flash memory card without power drop, provided the compact flash is not in use when you remove it.
  • Page 11: Removing A Compact Flash Memory Card

    Replacing a compact flash memory card while retaining the current announcements Procedure 1. Make sure the yellow CARD IN USE LED associated with the compact flash is off. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...
  • Page 12 Note: If you copied the announcement files one by one, you can restore them one by one using the gateway CLI command copy ftp announcement-file. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...
  • Page 13 8. Screw on the blank plate to cover the compact flash slot. January 2018 Installing the upgrade memory kit in the G450 and G430 Media Gateway...

This manual is also suitable for:

G430