Set Interface - Avaya G450 Cli Reference Manual

set interface

Use the set interface command to specify the glare-handling convention for a DS1 or BRI
link in SLS. This command also determines the polarity of the ISDN Layer 2 (LAPD) protocol
operation.
Note:
For a DS1 circuit, this command specifies the glare-handling convention for the
Note:
set connect
DS1 link.
Note:
This command is only valid for a DS1 or BRI circuit.
Note:
Syntax
set interface glare-mode
Parameters
Parameter
glare-mode
User Level
read-write
Context
sls > ds1
sls > bri
command that has been administered as pbx at the far-end of the
Description
The glare-handling convention for a DS1 or BRI
link.
For non-QSIG calls:
network – If the gateway is connected to a
●
host computer and encounters glare, it
overrides the far-end
user – If the gateway is connected to a
●
public network and encounters glare, it
releases the circuit
For QSIG calls:
peerMaster – SLS overrides the other end
●
when glare occurs
peerSlave – SLS releases the circuit when
●
glare occurs
SLS survivability
Possible Default
Values Value
network user
user
peerMaster
peerSlave
Issue 1 January 2008 931