Set Side - Avaya G450 Cli Reference Manual

Context
sls > station
sls > trunk-group
sls > ds1
sls > bri
Examples
To set the username Joe Smith for a given station:
G450-001 (sls-station-<extension>)# set name "Joe Smith"
Related Commands - Station commands
set cor, set expansion-module,
set type (station),
Related Commands - Trunk-group commands
add port, clear
set codeset-national,
incoming-destination,
send-name, set
(trunk-group), trunk-group
Related Commands - DS1 commands
clear ds1, set bearer-capability,
country-protocol,
set side, set signaling-mode,
Related Commands - BRI commands
bri, clear bri, set
directory-number-b,
set side, set spid-a,
Related Commands - SLS commands
set sls, show sls,

set side

Use the set side command to specify the glare-handling conditions when the
command has been administered as peerMaster or peerSlave for the ISDN link in SLS.
Note:
This command is only valid for ISDN.
Note:
set password,
show (station), station
tac, clear trunk-group,
set dial, set digits,
set incoming-dialtone,
send-number, set supervision,
set bit-rate,
set interface, set interface-companding,
show (ds1),
bearer-capability, set
set endpoint-init,
set spid-b, set tei-assignment,
sls
set port, set swhook-flash,
remove port, set channel-preference,
set digit-handling, set
set japan-disconnect,
set tac, set trunk-hunt,
set channel-numbering,
set
show ds1
country-protocol, set
set interface, set interface-companding,
show bri,
SLS survivability
set trunk-destination,
set codeset-display,
digit-treatment, set
set numbering-format,
show trunk-group,
set connect,
long-timer, set protocol-version,
directory-number-a, set
set
show (bri)
set interface
Issue 1 January 2008
set
show
set
layer1-stable,
935