Avaya G450 Cli Reference Manual page 894

CLI Commands
Syntax
traceroute host [local-address ip-addr] [probe-count count]
[dest-port-base dest-port] [dest-port-increment increment]
[source-port source-port] [timeout timeout] [dscp dscp] [next-hop
{next-hop-if-name | next-hop-ip-addr}] [max-ttl max-ttl] [size size]
[protocol protocol] [include-tunnel-hops] [set-df-bit]
Parameters
Parameter
host
ip_addr
count
dest-port
increment
source-port
timeout
dscp
next-hop-if
-name
next-hop-ip
-addr
max-ttl
size
protocol
894 Avaya G450 CLI Reference
Description
The destination host of the traceroute
probes, specified as an IP address or host
name
The local IP address of the traceroute probes
The number of times each TTL value is
repeated for a traceroute
The destination port of the first probe sent
An integer that determines by how much the
destination port is incremented for each
probe sent, starting from base port
The source port of the traceroute probes
The duration, in milliseconds, that traceroute
waits for a response for each probe sent,
until it gives up and marks this probe as
unreachable
The value of the DS field of the traceroute
probes
The interface name of the next hop
The IP address of the next hop
Do not probe over this TTL value
The L4 payload length, in bytes
The protocol type of the traceroute probes
Routing table configuration
Possible Default
Values Value
The
outbound
interface
address
1-5 3
1,024- 33,434
65,535
0-254 1
1,024- 33,434
65,535
10ms- 2 seconds
120sec in
in milliseconds
milliseconds
0-63 0
1-50 30
8-4,088 40
ICMP, UDP UDP