Avaya G450 Cli Reference Manual page 1252

CLI Commands
Uncomp bytes
Comp bytes
Incomp bytes
======================================================================
Output fields
Name
Inbound pkts
errors (global) *
Interface
Crypto list id
Local address
Rule
Crypto Map
Local address
Remote address
1252 Avaya G450 CLI Reference
0
0
0
Description
The global inbound packets' error statistics, as follows:
Invalid spi * — The number of packets received with an invalid
●
SPI (that does not resolve to any known SA
Invalid interface * — The number of packets received with an
●
SPI which is valid on a different interface than the one on which it
was received
The interface for which the following SA information is being displayed.
Note: If the crypto-list activated on the interface is also activated on
other interfaces, these interfaces are also listed here.
Note: Interfaces in the 'down' state are designated as such.
The ID of the crypto-list that contains the SAs being displayed
The local address configured for the crypto list, used for the local
tunnel endpoint of all traffic protected by SAs pertaining to the
crypto-list. The local address is either an interface name or an IP
address, depending on configuration.
The ID of the crypto-list rule that contains the SAs being displayed
The ID of the crypto-map that the rule points to, including its
user-defined description
The IP address of the local tunnel endpoint of traffic protected by this
SA.
Note: If NAT Traversal is used, the UDP encapsulation port number is
appended.
The IP address and, optionally, hostname of the remote peer. A
hostname is displayed if the peer was configured by its FQDN.
Note: If NAT Traversal is used, the UDP encapsulation port number is
appended.
* This parameter appears when the
#
This parameter appears when IP Payload Compression (IPPCP) is used.
&
The SA table is displayed only when active SAs exist for the rule.
Uncomp bytes
Comp bytes
Incomp bytes
detail keyword is specified.
VPN
0
0
0