Set Bit-Rate - Avaya G450 Cli Reference Manual

set bit-rate

Use the set bit-rate command to set the maximum transmission rate for the DS1 facility in
SLS.
Note:
This command is only valid for DS1.
Note:
If this command is invoked to change the transmission rate and the DS1 facility
and associated signaling group have already been provisioned, the command is
blocked and a warning message, "Administrative change is in violation with
existing trunk member provisioning", is displayed.
Syntax
set bit-rate rate
Parameters
Parameter Description
The maximum transmission rate for the DS1 facility:
rate
User Level
read-write
Context
sls > ds1
Example
To set the maximum transmission rate to 2.048 Mbps:
G450-001 (sls-ds1-<port address>)# set bit-rate 2048
Related Commands
clear ds1, set bearer-capability,
country-protocol,
protocol-version,
1544 – Sets the transmission rate at 1.544 Mbps (T1)
●
2048 – Sets the transmission rate at 2.048 Mbps (E1)
●
set bit-rate,
set interface, set interface-companding,
set side, set signaling-mode,
set channel-numbering,
set long-timer,
set sls, show (ds1),
SLS survivability
Possible Default
Values Value
1544 1544
2048
set connect, set
set name, set
show ds1, show sls, sls
Issue 1 January 2008 965