Page 1
Replacing a power supply unit ● Ordering equipment When ordering any of the field replaceable units, quote the following comcode: Table 1: Avaya G450 Media Gateway comcodes for customer and services ordering Product Comcode 80 channels DSP daughterboard (MP80 VoIP module)
MP20 or MP80 daughterboard or insert one into an empty slot. The slots are located on the G450 main board. You must pull out the main board to remove or insert a media resources module. The G450 supports hot insertion and removal of the main board without power drop.
Page 3
Replacing or inserting an MP20 or MP80 VoIP module Figure 1: Removing and inserting the main board Removing an MP20 or MP80 module ELECTROSTATIC ALERT: Hold modules only by the edges to avoid damage from static electricity. Do not ELECTROSTATIC ALERT: touch the top or bottom of the circuit board.
Page 4
45 degree angle to the main board, and start MP20 or MP80 inserting it into an slot (see Figure MP20 or MP80 4 Job Aid: Replacing the Field Replaceable Units (FRUs) for the Avaya G450 Media Gateway...
Page 5
Replacing or inserting an MP20 or MP80 VoIP module Figure 3: Inserting an MP20 or MP80 module 2. Push the module in all the way. Do not use too much force. 3. Flatten the module so it is flush with the main board. The latches at both sides click shut. Reinserting the main board To insert the main board: 1.
The fan system is field replaceable. It is mounted on a fan tray that can be replaced as one unit. The G450 supports hot swap of the fan tray. There is no need to power down or reset the G450 when replacing a faulty fan tray unit.
Page 7
OK. For example: G450-001(super)# show platform fans FAN TRAY UNIT #1: ------------------------------------------------- Type : G450 FAN TRAY Description : G450 FAN TRAY UNIT Serial Number : 0728IS123123 HW Vintage HW Suffix Faults : No Fault Messages 03-602059 Issue 1 January 2008...
PSUs, they operate in a load sharing mode. The G450 supports hot swap of the PSU. Even if you have only one PSU installed, there is no need to power down or reset the G450 when replacing a faulty PSU. You can install the replacement PSU in the second PWR slot, and it will become the active PSU once you remove the faulty PSU.
Page 9
OK. The upper PSU is referred to as PSU #1, and the lower PSU is PSU #2. For example: G450-001(super)# show platform power POWER SUPPLY UNIT #1: ------------------------------------------------- Type : G450 PSU Description : G450 FR Power Supply 400W Serial Number : 0735IS123321 HW Vintage HW Suffix Faults : No Fault Messages POWER SUPPLY UNIT #2:...
Page 10
Job Aid: Replacing the Field Replaceable Units (FRUs) for the Avaya G450 Media Gateway 10 Job Aid: Replacing the Field Replaceable Units (FRUs) for the Avaya G450 Media Gateway...
Need help?
Do you have a question about the G450 and is the answer not in the manual?
Questions and answers