Adj 18.1.3 Edge Erase Value Adjustment; Adj 18.2.1 Things To Take Note When Replacing Important Information Stored Components (Isc) - Xerox WorkCentre 5022 Service Manual

ADJ 18.1.3 Edge Erase Value Adjustment

Purpose
To correct both (Rear/Front) sides, Lead Edge and Tail Edge erase values of the image.
NOTE: The IOT Lead Edge/Side Edge Registration must be adjusted.
Check
1. Specify a Tray loaded with paper. Make a black copy without using any originals and leav-
ing the Platen Cover open.
2. Check that the white sections of the Lead Edge, Tail Edge, and both Side Edges are 4
mm.
Adjustment
1. Enter the CE Mode.
2. Adjust the NVM until the white sections of the Lead Edge, Tail Edge, and both Side Edges
are 4 mm.
Increasing the setting value increases the amount of edge erase for the Lead Edge, Tail
Edge, and both Sides.
This setting affect all 4 sides equally and it is not possible to perform individual setting for
the Lead Edge only, etc.
Table 1 NVM List
Chain-
Link Name Min
780-066 Edge Erase Copy Job 0
3. After adjustment, make another black copy without using any originals and leaving the
Platen Cover open.
4. Adjust until the white sections of the Lead Edge, Tail Edge, and both Side Edges are 4
mm.
Repairs and Asdjustments
Initial Max Step
40 500 0.1
mm
ADJ 18.2.1 Things to take note when replacing Important
Information Stored Components (ISC)
Purpose
After installation, any data that the customer has registered are very important. To lose or leak
the data would be an unforgivable offence. To gain the trust of customers, it is essential for CE
to be knowledgeable about the name of components that store these data. The CE must also
have full understanding on how to handle these components when replacing them.
Adjustment
This product stores important data in the following components. Perform the operation accord-
ing to the following procedures.
NOTE: IBG) Collect/discard components according to the separately pre-determined proce-
dures.
Component
Name Stored Information
1 EEP ROM • Product Code
(ESS/MCU
• Serial Number
PWB)
• Copy Counter/
Print Counter
• HFSI Counter
(IIT/IOT)
• Machine Sys-
tem Parameter
2 EEP ROM • MAC Address
(NET I/F
• IP Address
PWB)
• Network Sys-
tem Parameter
06/2014
4-102
Table 1
Pre-replacement Post-replacement
operation operation
To restore the settings Restore all settings by using
later, print the reports. the reports, etc.
When replacing the When replacing the PWB,
PWB, remove the remove the EEP ROM from
EEP ROM from the the old PWB, and install it to
old PWB, and install it the new one.
to the new one.
To restore the settings Restore all settings by using
later, print the reports. the reports, etc.
When replacing the When replacing the PWB,
PWB, remove the remove the EEP ROM from
EEP ROM from the the old PWB, and install it to
old PWB, and install it the new one.
to the new one.
WC 5022/5024
Version 1.0