Igmp Interface Configuration - D-Link DES-3326SR Manual

D-Link DES-3326SR Layer 3 Switch

IGMP Interface Configuration

IGMP for IP interfaces function the same way they do for individual ports or VLANs in Layer 2. Most of the
parameters are the same as well, except instead of configuring for VLANs you are setting up IGMP for different
subnets (IP interfaces).
To configure an IGMP Interface on the switch, click on the IGMP Interface Configuration link under the IP
Multicast Routing Protocols folder:
Figure 21- 4. IGMP Interface Setup
The Internet Group Multicasting Protocol (IGMP) can be configured on the switch on a per-IP interface basis.
Each IP interface configured on the switch is displayed in the above IGMP Interface Configuration dialog box.
To configure IGMP for a particular interface, click the corresponding click-box for that IP interface and click the
Edit button. This will open the following dialog box:
Figure 21- 5. IGMP Interface Configuration − Edit
This dialog box allows the configuration of IGMP for each IP interface configured on the switch. IGMP can be
configured as Version 1 or 2 by toggling the Version field using the pull-down menu. The length of time
between queries can be varied by entering a value between 1 and 65,500 seconds in the Query Interval field.
The maximum length of time between the receipt of a query and the sending of an IGMP response report can be
varied by entering a value in the Max Response Time field.
147