Show Ip Route - D-Link DGS-1250 Series Reference Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide
This example shows how to display the IP interface information for VLAN 1.
Switch#show ip interface vlan 1
Interface vlan1 is enabled, Link status is up
IP address is 10.90.90.90/8 (Manual)
ARP timeout is 240 minutes.
Total Entries: 1
Switch#
2-26

show ip route

This command is used to display the entry in the routing table.
show ip route [IP-ADDRESS [MASK] | connected | static | hardware]
Parameters
IP-ADDRESS
MASK
connected
static
hardware
Default
None.
Command Mode
EXEC Mode.
Any Configuration Mode.
Usage Guideline
Use this command to display the best routes that are currently at work.
(Optional) Specifies the network address of which routing information should be
displayed.
(Optional) Specifies the subnet mask for the specified network.
(Optional) Specifies to display directly connected route.
(Optional) Specifies to display the static route.
(Optional) Specifies to display the routes that have been written into chip.
26