Tracert - Huawei S1700 Series Web User Manual

S1700 Managed Series Ethernet Switches
Web User Manual
----End

11.7.2 Tracert

Tracert is a utility program used to confirm the route that IP packet will take to access the
target. Tracert determines the route from a host to another host in the network by sending
ICMP error packets with time-to-live (TTL) values.
Click Device Management> Tools >Tracert, the configuration page is displayed as follows.
Figure 11-11 Tracert
Table 11-9 Parameters of Tracert
Item
IP Address
TTL
Timeout
Probe Times
Implement Tracert Ping test
Step 1 Click Device Management> Tools.
Step 2 Click Tracert in tab.
Step 3 Enter target IP address to be tested in IP Address, and then click Start button to test route
from source address to destination address.
Step 4 The result will display in IPv4 Tracert Result field.
----End
Issue 05 (2012-10-25)
Description
Enter IP address which needs to do Tracert test.
Enter the lifetime of IP packets. Tracert determines the route by
incrementing the TTL value by 1 on each subsequent transmission until
the target responds, or reaches the maximum TTL value
Enter the maximum response time of Tracert test. The test ignores the
responding from the target if the value is exceeded, then sends out the
next testing message.
Enter the value that is the retrying times after the failure of tracert test with the
same TTL value.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 Device Management
216