Drive Select Cable - Subaru 2002 IMPREZA Service Manual

CONTROL SYSTEMS

6. Drive Select Cable

A: REMOVAL
1) Remove the drive select lever. <Ref. to CS-18,
REMOVAL, MT Drive Select Lever.>
2) Remove the intake duct. <Ref. to IN-7, Air Intake
Duct.>
3) Remove the air cleaner case. <Ref. to IN-6, Air
Cleaner Case.>
4) Remove the snap ring and clevis pin.
5) Loosen the nut and disconnect the cable from
cable bracket.
(A) Snap pin
(B) Clevis pin
(C) Nut
6) Remove the cable from the under side of vehi-
cle.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Make sure the drive select lever operates prop-
erly.
C: INSPECTION
1) Make sure to move the transmission to HI or LO
position by moving the drive select lever. If it
doesn't, adjust the cable.<Ref. to CS-20, ADJUST-
MENT, Drive Select Cable.>
2) Make sure the cable operates smoothly. If it
catches or fails to work properly, repair or replace
it.
3) Check the cable for damage.
DRIVE SELECT CABLE
D: ADJUSTMENT
1) Set the drive select lever to HI position.
2) Remove the drive select lever knob.
3) Remove the console box. <Ref. to EI-40, Con-
sole Box.>
4) Loosen the nut.
5) Make sure the transmission is in HI position. If
isn't, pull on the cable to put transmission in HI po-
sition.
6) Tighten the nut in the location where cable end
bolt stops naturally.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
7) Make sure to move the transmission to HI or LO
position by moving the drive select lever. If it
doesn't, readjust the cable.
S3M0641A
B3M0769
CS-20