Select Cable - Subaru IMPREZA 2002 Service Manual

SELECT CABLE
I
CONTROL SYSTEMS
10) Disconnect the cable from select lever and then
remove the cable bracket.
5. Select Cable
A: REMOVAL
1) Set the vehicle on the lift.
2) Disconnect the ground terminal from battery.
3) Prior to removal, set the lever to "N" position.
4) Lift-up the vehicle.
5) Remove the front and center exhaust pipe. (Non-
turbo model) <Ref. to EX(S0HC)-5, REMOVAL,
Front Exhaust Pipe.>
CAUTION:
When removing the exhaust pipes, be careful
each exhaust pipe does not drop out.
6) Remove the center exhaust pipe. (Turbo model)
<Ref. to EX(D0HC TURBO)-8, REMOVAL, Center
Exhaust Pipe.>
(A) Adjusting nuts
(B) Cable bracket
7) Remove' the heat shield cover. (If equipped)
8) Remove the snap pin from range select lever.
11) Remove the select cable from plate assembly.
(A) Range select lever
(B) Snap pin
(C) Select cable
(D)
Clamp
9) Remove the plate assembly from transmission
case
I
(A) Select cable
(B) Plate ASSY
(C) Clamp
CS-26