Settings; Monitored Data - ABB 615 series Technical Manual

1MAC059074-MB A
3.20.2.4
3.20.2.5
615 series ANSI
Technical Manual
Table 205: SCHLCCH3 output signals
Parameter Values (Range)
CH3LIV True
False
LNK3LIV Up
Down

Settings

Table 206: Port mode settings
Parameter Values (Range)
Port 1 Mode Off
On
Port 2 Mode Off
On
Port 3 Mode Off
On

Monitored data

Monitored data is available in six locations.
• Monitoring/Communication/Ethernet/Activity/CH1LIV
• Monitoring/Communication/Ethernet/Activity/CH2LIV
• Monitoring/Communication/Ethernet/Activity/CH3LIV
• Monitoring/Communication/Ethernet/Link statuses/LNK1LIV
• Monitoring/Communication/Ethernet/Link statuses/LNK2LIV
• Monitoring/Communication/Ethernet/Link statuses/LNK3LIV
Unit Step Default Description
Status of Ethernet channel X3/LAN. Value
is "True" if the port is receiving Ethernet
frames. Valid only when
is set to "None" or port is not one of the
redundant ports (LAN A or LAN B).
Link status of Ethernet port X3/LAN.
Unit Step Default Description
On Mode selection for rear port(s). If port is not
used, it can be set to "Off". Port cannot be
set to "Off" when
"HSR" or "PRP" and port is one of the
redundant ports (LAN A or LAN B) or when
port is used for line differential
communication.
On Mode selection for rear port(s). If port is not
used, it can be set to "Off". Port cannot be
set to "Off" when
"HSR" or "PRP" and port is one of the
redundant ports (LAN A or LAN B).
On Mode selection for rear port(s). If port is not
used, it can be set to "Off". Port cannot be
set to "Off" when
"HSR" or "PRP" and port is one of the
redundant ports (LAN A or LAN B).
Section 3
Basic functions
Redundant mode
Redundant mode is
Redundant mode is
Redundant mode is
209