ABB 615 series Technical Manual page 329

1MAC059074-MB A
Parameter Values (Range)
Curve parameter C 0.02...2.00
Curve parameter D 0.46...30.00
Curve parameter E 0.0...1.0
Table 334: 50N,50G Non group settings (Advanced)
Parameter Values (Range)
Minimum trip time 20...60000
Reset delay time 0...60000
Measurement mode 1=RMS
2=DFT
3=Peak-to-Peak
IG/I0 signal Sel 1=Measured IG
2=Calculated I0
Table 335: 50N-3,50G-3 Group settings (Basic)
Parameter Values (Range)
Pickup value 1.00...40.00
Pickup value mult 0.8...10.0
Trip delay time 20...200000
Table 336: 50N-3,50G-3 Non group settings (Basic)
Parameter Values (Range)
Operation 1=enable
5=disable
Table 337: 50N-3,50G-3 Non group settings (Advanced)
Parameter Values (Range)
Reset delay time 0...60000
IG/I0 signal Sel 1=Measured IG
2=Calculated I0
615 series ANSI
Technical Manual
Unit Step Default
1 2.00
1 29.10
1 1.0
Unit Step Default
ms 1 20
ms 1 20
2=DFT
1=Measured IG
Unit Step Default
xIn 0.01 1.00
0.1 1.0
ms 10 20
Unit Step Default
1=enable
Unit Step Default
ms 1 20
1=Measured IG
Protection functions
Description
Parameter C for customer programmable
curve
Parameter D for customer programmable
curve
Parameter E for customer programmable
curve
Description
Minimum trip time for IDMT curves
Reset delay time
Selects used measurement mode
Measured IG or calculated I0
Description
Pickup value
Multiplier for scaling the pickup value
Trip delay time
Description
Operation Disable / Enable
Description
Reset delay time
Measured IG or calculated I0
Section 4
323