ABB 615 series Technical Manual page 70

Section 3
Basic functions
Parameter Values (Range)
Web HMI timeout 1...60
SLD symbol format 1=IEC
2=ANSI
Autoscroll delay 0...30
Setting visibility 1=Basic
2=Advanced
Table 18: IEC 61850-8-1 MMS settings
Parameter Values (Range)
Unit mode
1=Primary
0=Nominal
2=Primary-
Nominal
1) MMS client expects primary values from event reporting and data attribute reads
2) MMS client expects nominal values from event reporting and data attribute reads; this is the default for PCM600
3) For PCM600 use only, When Unit mode is set to "Primary", the PCM600 client can force its session to "Nominal" by selecting "Primary-Nominal"
and thus parameterizing in native form. The selection is not stored and is therefore effective only for one session. This value has no effect if
selected via the LHMI.
Table 19: Modbus settings
Parameter Values (Range)
Operation 1=enable
5=disable
Port 1=COM 1
2=COM 2
3=Ethernet - TCP 1
Mapping selection 1...2
Address 1...254
Link mode 1=RTU
2=ASCII
TCP port 1...65535
Parity 0=none
1=odd
2=even
Start delay 0...20
End delay 0...20
CRC order 0=Hi-Lo
1=Lo-Hi
Table continues on next page
64
Unit Step
min 1
s 1
Unit Step
1)
2)
3)
Unit Step
1
1
1
1
1
Default Description
3 Web HMI login timeout
1=IEC Single Line Diagram symbol format
0 Autoscroll delay for Measurements view
1=Basic Setting visibility for HMI
Default Description
0=Nominal IEC 61850-8-1 unit mode
Default Description
5=disable Enable or disable this protocol instance
3=Ethernet - TCP Port selection for this protocol instance. Select
1 between serial and Ethernet based
communication.
1 Chooses which mapping scheme will be used
for this protocol instance.
1 Unit address
1=RTU Selects between ASCII and RTU mode. For
TCP, this should always be RTU.
502 Defines the listening port for the Modbus TCP
server. Default = 502.
2=even Parity for the serial connection.
4 Start delay in character times for serial
connection
4 End delay in character times for serial
connections
0=Hi-Lo Selects between normal or swapped byte order
for checksum for serial connection. Default: Hi-
Lo.
1MAC059074-MB A
615 series ANSI
Technical Manual