Settings - ABB 615 series Technical Manual

1MAC059074-MB A
3.13.4
Table 58: RTD input settings
Parameter Values (Range)
Input mode 1=Not in use
2=Resistance
10=Pt100
11=Pt250
20=Ni100
21=Ni120
22=Ni250
30=Cu10
Input maximum 0...2000
Input minimum 0...2000
Value unit 1=Dimensionless
5=Ampere
23=Degrees
celsius
30=Ohm
Value maximum -10000.0...10000.0
Value minimum -10000.0...10000.0
Val high high limit -10000.0...10000.0
Value high limit -10000.0...10000.0
Value low limit -10000.0...10000.0
Value low low limit -10000.0...10000.0
Value deadband 100...100000
Table 59: mA input settings
Parameter Values (Range)
Input mode 1=Not in use
5=0..20mA
Input maximum 0...20
Input minimum 0...20
Value unit 1=Dimensionless
5=Ampere
23=Degrees
celsius
30=Ohm
Table continues on next page
615 series ANSI
Technical Manual

Settings

Unit Step
Ω 1
Ω 1
1
1
1
1
1
1
1
Unit Step
mA 1
mA 1
Default Description
1=Not in use Analogue input mode
2000 Maximum analogue input value for mA or
resistance scaling
0 Minimum analogue input value for mA or
resistance scaling
1=Dimensionless Selected unit for output value format
10000.0 Maximum output value for scaling and
supervision
-10000.0 Minimum output value for scaling and
supervision
10000.0 Output value high alarm limit for supervision
10000.0 Output value high warning limit for supervision
-10000.0 Output value low warning limit for supervision
-10000.0 Output value low alarm limit for supervision
1000 Deadband configuration value for integral
calculation. (percentage of difference between
min and max as 0,001 % s)
Default Description
1=Not in use Analogue input mode
20 Maximum analogue input value for mA or
resistance scaling
0 Minimum analogue input value for mA or
resistance scaling
1=Dimensionless Selected unit for output value format
Section 3
Basic functions
127