ABB 615 series Technical Manual page 954

Section 8
Measurement functions
948
Parameter Values (Range)
High trigger 0.00...60.00
level
Low trigger 0.00...2.00
level
Storage mode 0=Waveform
1=Trend / cycle
1) Recordable values are available only in trend mode. In waveform mode, samples for this signal type are
constant zeroes. However, these signal types can be used to trigger the recorder on limit violations of the
corresponding analog channel.
Table 851: DFR Non-group binary channel settings
Parameter Values (Range)
Operation 1=Enable
5=Disable
Level trigger 1=Positive or
mode Rising
2=Negative or
Falling
3=Both
4=Level trigger
off
Storage mode 0=Waveform
1=Trend / cycle
Channel id text 0 to 64
characters,
alphanumeric
Table 852: DFR Control data
Parameter Values (Range)
Trig recording 0=Cancel
1=Trig
Clear 0=Cancel
recordings 1=Clear
Unit Step
pu 0.01
pu 0.01
1
Unit Step
1
1
1
Unit Step
1MAC059074-MB A
Default Description
10.00 High trigger
level for the
analog channel
0.00 Low trigger
level for the
analog channel
0 Storage mode
for the analog
channel
Default Description
5=Disable Binary channel
is enabled or
disabled
1=Rising Level trigger
mode for the
binary channel
0 Storage mode
for the binary
channel
DR binary Identification
channel X text for the
analog channel
used in the
COMTRADE
format
Default Description
Trigger the
disturbance
recording
Clear all
recordings
currently in
memory
615 series ANSI
Technical Manual