Auto Registration Sensor Pcb - Canon imagerunner C5180 Service Manual

Chapter 9
3) Connect the connector [1]; then, while pulling the
escape lever [2] toward the front, hook the plate
[3] on the left/right claw [4], and secure it in place
with a screw [5] over the screw hole.
F-9-139

9.9.19 Auto Registration Sensor PCB

9.9.19.1 Preparation for Removing the
Auto Registration Sensor PCB
1) Slide out the manual feed unit.
2) Removing the intermediate transfer unit. (page 9-
60)Reference[Removing
Transfer Unit]
3) Remove the upper right cover. (page 12-
20)Reference[Removing the Upper Right Cover]
4) Remove the pattern reader unit. (page 9-
79)Reference[Removing the Pattern Reader Unit]
9-80
the Intermediate
9.9.19.2 Removing the Auto Registration
Sensor PCB
1) Remove the plate found to the rear of the pattern
reader unit [2].
- 3 screws [1]
F-9-140
2) Remove the auto registration sensor PCB (front)
[3].
- 2 screws [1]
- 2 connectors [2]
MEMO:
The auto registration sensor PCB (rear) is also
removed in the same way.
F-9-141