Copier; Test (Test Print Mode) - Canon imagerunner C5180 Service Manual

Chapter 19

19.6 TEST (Test Print Mode)

19.6.1 COPIER

19.6.1.1 COPIER Table
1. PG
Sub item
TYPE Performs test print when test print type number is entered and start key is turned ON. (This
setting must always be restored to 0 after making test print.)
Setting values
0: Normal print, 0 to 100
[Factory default/After RAM clear: 0]
TXPH Used to set image mode during test print output.
Setting values
0: Text mode
1: Photo mode
2: Automatic mode
3: Text/photo/map mode
4: Photographic printing paper photo mode
5: Printed photo mode
6: Text/photo mode
7: Black and white text mode
Reference:
This setting is only valid for test prints.
[Factory default/After RAM clear: 0]
THRU Used to select whether to use image compensation table during test print output.
Setting values
0: ON (Use)
1: OFF (Don't use)
[Factory default/After RAM clear: 0]
DENS-Y/M/C/K Used to adjust density of each color for test prints (TYPE = 5).
Setting values
0 to 255: Increasing the value increases the density.
[Factory default/After RAM clear: 128]
COLOR-Y/M/C/ Used to set output of each color for each TYPE.
K For example, to set single-color M output, set "COLOR-M = 1", and make the other
settings 0 (only single colors can be output).
Setting values
0: Don't output
1: Output
[Factory default/After RAM clear: 1]
F/M-SW Set it to switch over full color and mono color during PG output.
Settings
0: full color output
1: mono color output
[Factory default/After RAM clear: 0]
19-124
T-19-68
COPIER>TEST>PG
Description level.
1
1
1
1
1
1