Slide Resistor - Canon imagerunner C5180 Service Manual

Chapter 10

10.10.13 Slide Resistor

10.10.13.1 Preparation for Removing the
Slide Resistor
1) Remove the manual feed unit.(page 10-
52)Reference[Removing the Manual Feed Unit]
2) Removing the manual feed tray unit.(page 10-
52)Reference[Removing the Manual Feed Tray
Unit]
3) Remove the manual feed tray upper cover/lower
cover.
3-1) Spread the side guide [1] of the manual feed tray
unit, and remove the upper cover [2].
[2]
[B]
[A]
F-10-92
MEMO:
When attaching the upper cover [1] and the lower
cover [2], match the markings [A] found on the side,
and move them into place.
10-50
[A]
[1]
F-10-93
10.10.13.2 Removing the Slide Resistor
Points to Note Removing the Slide Resistor
When removing the slide resistor, do not apply
excess force when spreading the claw of the lower
cover; otherwise, the claw can break.
When attaching the slide resistor, take care not to
touch the connector [1] at the edge of the slide
resistor. Try to match the black protrusion [A]
behind the slide resistor against the hole [A] in the
tray.
F-10-94