Canon imagerunner C5180 Service Manual page 641

Displayed Detection timing
code
0000 When the reader controller PCB has
detected trouble in communication
between the main controller PCB
and reader controller PCB
E744 Language file/BootROM error
0001 When the language version on the
HDD and the bootable version do
not match
0002 When the size of the language on
the HDD is too large
0003 When the language which is
described in Config.txt on the HDD
and which is to be selected cannot
be found
When it is not possible to switch to
the language on the HDD
0004 When it is not possible to switch to
the language on the HDD
1000 When the BootROM of a different
model has been connected
1001 When the system and BootROM
versions do not match
2000 When an illegal engine ID has been
detected
4000 When an illegal DC controller PCB
has been detected
E747 Main controller PCB error
0000- Error on the main controller PCB
1217 (main)
2000- Error in communication with main
3D00 controller PCB (sub PE)
3F00, When the non-mounting of the
3F02 main controller PCB (sub PE) has
been detected
6000- Error in communication with main
7D00 controller PCB (sub R)
7F00 When the non-mounting of the
main controller PCB (sub R) has
been detected
8000- Error in communication with the
9C00 OPEN interface PCB
9F00 When the non-mounting of the
main controller PCB (sub R) has
been detected
C000- Error in communication with the
DC00 main controller PCB (sub SJ)
DF00 When the non-mounting of the
main controller PCB (sub SJ) has
been detected
FF00 When an illegal main controller
PCB (sub SJ, PE or R) or OPEN
interface PCB has been detected
Remedial action
Disconnect and re-connect the reader communication cable connector, or
replace the reader controller PCB. Replace the main controller PCB.
Upgrade the language file version.
Replace the BootROM.
Replace the BootROM. Upgrade the system version.
Re-install the system.
Upgrade the DC controller PCB version.
Turn the main power OFF and back ON. Replace the main controller PCB
(main).
Disconnect and re-connect the main controller PCB (sub PE) or replace.
Replace the main controller PCB (main).
Disconnect and re-connect the main controller PCB (sub PE) or replace.
Disconnect and re-connect the main controller PCB (sub R) or replace.
Replace the main controller PCB (main).
Disconnect and re-connect the main controller PCB (sub R) or replace.
Disconnect and re-connect the OPEN interface PCB or replace. Replace the
main controller PCB (main).
Disconnect and re-connect the main controller PCB (sub R) or replace.
Disconnect and re-connect the main controller PCB (sub SJ) or replace.
Replace the main controller PCB (main).
Disconnect and re-connect the main controller PCB (sub SJ) or replace.
Replace with the main controller PCB (sub SJ, PE or R) or OPEN interface
PCB designed for this unit.