Canon imagerunner C5180 Service Manual page 627

Displayed Detection timing
code
E110 Laser scanner motor running trouble
0110 Trouble in the running of the laser
scanner motor for Y
0210 Trouble in the running of the laser
scanner motor for M
0310 Trouble in the running of the laser
scanner motor for C
0410 Trouble in the running of the laser
scanner motor for Bk
E193
0001 Initializing error of the image ASIC
on the DC controller PCB 2 (IMG)
E202 1st mirror stand HP detection trouble
0001 The 1st mirror stand fails to move
tTransparency even when it
retracts.
0002 The 1st mirror stand fails to move
from HP even when it advances.
E225 Exposure lamp lighting trouble
0001 Light quantity of the exposure lamp
has dropped.
E227 Reader unit power supply error
0001 When the 24 V port is OFF when
the power is turned ON.
0002 When the 24 V port is OFF when a
job is started.
0003 When the 24 V port is OFF when a
job is finished.
0004 When the 24 V port is OFF during
load drive.
E240 Error in communication between main controller and DC controller
0000 Serial communication error
0002 When the response from the DC
controller does not arrive within the
prescribed period of time during
printing
E248 Defective EEPROM on reader controller PCB
0001 Error when the power of the reader
controller EEPROM is turned ON
0002 Error when data is written into the
reader controller EEPROM
0003 Reader controller EEPROM check
error or error when data is read after
it was written
E315 Image data trouble
000e Damaged data (trouble in memory
or HDD)
Software decoding error
E351 Main controller PCB error
Remedial action
Replace the laser scanner (Y) and the DC controller PCB 1 (IMG).
Replace the laser scanner (M) and the DC controller PCB 1 (IMG).
Replace the laser scanner (C) and the DC controller PCB 1 (IMG).
Replace the laser scanner (Bk) and the DC controller PCB 1 (IMG).
Replace the DC controller PCB 2 (IMG).
Replace the optical system HP sensor, optical system motor and reader
controller PCB.
Replace the optical system HP sensor, optical system motor and reader
controller PCB.
Clean the white plate. Replace the exposure lamp.
Disconnect and re-connect the power connector. Replace the power supply.
Check the connector connections. Check the DC controller PCB (MAISY).
Replace the No.1 main controller circuit.
Replace the reader controller PCB.
Replace the image memory (SDRAM) or HDD.
Chapter 18
18-9