Canon imagerunner C5180 Service Manual page 629

Displayed Detection timing
code
0001 When the offset HP sensor fails to
turn ON even though the offset
motor was driven for 1000 ms
toward the HP sensor approach side
while the motor was running
0002 When the offset HP sensor fails to
turn OFF even though the offset
motor was driven for 1000 ms
toward the HP sensor escape side
while the motor was running
E530 Alignment error
8001 When the alignment plate fails to
leave the alignment plate front
home position sensor position even
when the alignment plate front
motor was driven for 4 sec.
8002 When the alignment plate fails to
return to the alignment plate front
home position sensor position even
when the alignment plate front
motor was driven for 4 sec.
E531 Stapler error
0001 When the stapler unit failed to leave
the stapler home position even
though 400 ms elapsed since the
stapler operation started
0002 When the stapler unit left the
stapler home position but then
failed to reach the stapler home
position even though 400 ms
elapsed since the stapler operation
started. When the unit failed to
reach the stapler home position
within 400 ms even after operation
in the reverse direction.
8001 When the stapler fails to leave the
stapler home position even though
the stapler motor was driven for 0.5
sec.
8002 When the stapler fails to return to
the stapler home position even
though the stapler motor was driven
for 0.5 sec.
E532 Stapler movement error
8001 When the stapler fails to leave the
stapler movement home position
even though the stapler movement
motor was driven for 5 sec.
8002 - When the stapler fails to return to
the stapler movement home
position even though the stapler
movement motor was driven for 20
sec.
- When the stapler was not at the
home position and the stapler
alignment interference sensor was
actuated
Remedial action
- Check the offset HP sensor connectors.
- Check the offset motor connectors.
- Replace the offset HP sensor.
- Replace the offset motor.
- Replace the finisher controller PCB.
Replace the alignment plate front motor (M103) and alignment plate front
home position sensor (PI106).
- Check the stapler unit connectors.
- Replace the stapler unit.
- Replace the finisher controller PCB.
Replace the stapler motor (M111) and stapler home position detection
sensor (PI50).
Replace the stapler movement motor (M105) and stapler movement home
position sensor (PI110).
Chapter 18
18-11