Canon imagerunner C5180 Service Manual page 725

Chapter 19
TMC-SLCT Used to select coefficient used in error diffusion process.
0: Low granularity/low dot stability for Y/M/C/Bk
1: Y/M/C -> Low granularity, low dot stability, Bk -> high granularity, low dot stability [Factory
default/After RAM clear]
2: High granularity/low dot stability for Y/M/C/Bk
CAL-SW Used to switch condition for performing calibration control.
Whenever possible, avoid using this setting during normal operation.
CLN-PTH Sets threshold value (number of sheets) for starting drum cleaning sequence.
Whenever possible, avoid using this setting during normal operation.
CLN-VTH Sets threshold value (image density) for starting drum cleaning sequence.
Whenever possible, avoid using this setting during normal operation.
DEVL-VTH Sets threshold value (video count) for starting toner forcible consumption sequence.
Whenever possible, avoid using this setting during normal operation.
FTPTXPN Used to specify port (FTP) number to send to.
0 to 65535 (16-bit value) [Factory default/After RAM clear: 21]
PRNT-ORD Used to switch order of output to side tray.
Whenever possible, avoid using this setting during normal operation.
INTPPR-1 Sets interval (number of sheets) for performing image stabilization control (adjustment set 1) between
sheets.
0.50 to 1000 [Factory default/After RAM clear: 100]
DWNSQ- Used to improve tray loading during one-sided continuous printing.
SW Whenever possible, avoid using this setting during normal operation.
PRN-FLG Used to select area flag for PDL images.
Whenever possible, avoid using this setting during normal operation.
SCN-FLG Used to select area flag for copy images.
Whenever possible, avoid using this setting during normal operation.
T-LW-LVL Used to switch timing for display of remaining toner volume warning message.
Whenever possible, avoid using this setting during normal operation.
DVTGT-Y/ developer concentration target value offsets
M/C/K Whenever possible, avoid using these settings during normal operation.
NWERR- Used to select whether to display network error messages.
SW 0: Don't display
1: Display [Factory default/After RAM clear]
FX-SPD Used to adjust fixing roller speed.
-2 to 2
[Factory default/After RAM clear: 0]
Increasing the setting value increases the fixing roller's speed (in 0.8% increments).
Setting this value automatically increases the operation speed of the paper delivery vertical path motor
(the speed increases by the same ratio as the speed of the fixing roller).
EX-PS-SP Used to adjust paper delivery vertical path motor speed.
-2 to 2
[Factory default/After RAM clear: 0]
FX-N-ROT Used to turn fixing motor idle after warmup ON/OFF.
0: ON (idle) [Factory default/After RAM clear]
1: OFF (don't idle)
Setting this value to 1 increases the amount of paper curl, and reduces the capacity for the load on the
paper delivery tray.
FX-SUB Sets the fixing sub-heater's lighting ratio.
0: Normal [Factory default/After RAM clear]
1: Level 1
2: Level 2
Increasing this setting value decreases the lighting ratio (shortens the lighting time).
19-80
COPIER>OPTION>BODY
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2