Secondary Transfer Internal Roller - Canon imagerunner C5180 Service Manual

9.9.12 Secondary Transfer Internal
Roller
9.9.12.1 Preparation for Removing the

Secondary Transfer Internal Roller

1) Slide out the manual feed unit.
2) Removing the intermediate transfer unit. (page 9-
60)Reference[Removing
Transfer Unit]
3) Remove the intermediate transfer belt. (page 9-
63)Reference[Removing
Transfer Belt]
9.9.12.2 Removing the Secondary
Transfer Internal Roller
1) Extend the belt frame, and fit the link plate at both
front and rear.
2) Remove the positioning block [2] at the rear.
- 2 screws [1]
F-9-99
3) Remove the E-ring [1], gear [2], and bushing [3].
F-9-100
the Intermediate
the Intermediate
[3]
[1]
[2]
4) Remove the secondary transfer internal roller [3].
- 1 E-ring [1]
- 1 bushing [2] at the front
F-9-101
Points to Note When Attacing the Secondary
Transfer Internal Roller
When Attaching the bushing at the front, be sure to
fit the bushing [2] while avoiding the spring [1]
found on the inner side of the frame.
F-9-102
Chapter 9
9-69