Feedscrew Rotation Sensor - Canon imagerunner C5180 Service Manual

9.9.15 Feedscrew Rotation Sensor

9.9.15.1 Preparation for Removing the
Feedscrew Rotation Sensor
1) Remove the waste toner container.
1-1) Open the front cover, and turn the intermediate
transfer unit releasing lever [1].
F-9-114
1-2) Remove the waste toner container [2].
F-9-115
2) Remove the rear fan cover. (page 12-
22)Reference[Removing the Rear Fan Cover]
3) Remove the rear upper cover. (page 12-
22)Reference[Removing the Rear Upper Cover]
4) Remove the rear lower cover.(page 12-
23)Reference[Removing the Rear Lower Cover]
5) Remove the rear left cover (upper). (page 12-
23)Reference[Removing the Rear Left Cover
(Upper)]
6) Remove the left rear cover (upper). (page 12-
21)Reference[Removing the Left Rear Cover
(Upper)]
7) Remove the main controller box. (page 5-
23)Reference[Removing the Main Controller
Box]
8) Remove the DC controller box 2. (page 12-
31)Reference[Removing the DC Controller
Box2]
9) Remove the DC controller box 1. (page 12-
32)Reference[Removing the DC Controller
Box1]
10) Remove the high-voltage unit 1.(page 12-
27)Reference[Removing
Unit1]
11) Remove the mount [3].
- 19 connectors attached to the mount
- 7 clamps [1] (Remove the harness of the
developing motor.)
- 4 screws [2]
F-9-116
12) Remove the toner container drive unit.(page 9-
71)Reference[Removing the Toner Container
Drive Unit]
13) Remove the toner container drive assembly top
plate [7].
- screw [1]
- 2 E-rings [2]
- 2 bushings [3]
- harness from the edge saddle [4]
- harness [5] of the toner container motor from the
cord clamp [6]
Chapter 9
the High-Voltage
[2] [3]
[1]
9-73