Canon imagerunner C5180 Service Manual page 306

F-9-85
8) After bending the transfer frame, pull out the
transfer belt [1] upward.
F-9-86
When pulling out the belt, be careful not to break it
by pressing it against the unit.
F-9-87
[1]
After removing the belt, set it up to prevent damage,
or place it on a paper.
Check that there is no dirt on the secondary transfer
internal roller. When it is dirty, clean it with alcohol.
Cautions in attaching the intermediate
transfer belt
1) Attach it so that the red mark on the intermediate
transfer belt rib is placed in the rear side.
2) When attaching the belt, place the unit at a low
level so that the belt can be inserted straight from
the upper level.
3) Be careful so that the rib [2] in the belt [1] does not
run into the tension roller [3].
Chapter 9
[1]
F-9-88
F-9-89
9-65