Canon imagerunner C5180 Service Manual page 722

DFDST-L2 A higher setting will increase the level of dust detection (i.e., the machine will be more sensitive in
detecting dust, which if left behind will cause thin lines in the images).
settings range
0 to 255
[Factory default/After RAM clear: 200]
ENVP-INT Setting log correction interval of inner machine temperature/humidity/fixing temperature
Setting log collection interval to COPIER>FUNCTION>MISC-P>ENV-PRT and
COPIER>DISPLAY>ENVRNT
Settings
0 to 480 <min>
[Factory default/After RAM clear: 60]
Reference Log is not collected when '0' is set.
BLNK-THP Switches leading edge margin for paper thicker than thick 1, 2. (Colour only.)
This paper leading edge lateral stripe countermeasure.
Setting values
0: Default margin
1: Leading edge margin centre value made 7 mm.
[Factory settings and after RAM clear: 0]
FX-SPD2 Fixing roller speed fine tuning (for half speed)
Allows adjustment of TBF speed when half speed is being used.
Setting range: -5 to 5
[Factory settings and after RAM clear: 0]
CNTR-DSP Selecting screen in response to the external controller
Settings
0: The external controllericon is displayed on the control panel of the copier[Factory default/After
RAM clear]
(When the color image server is connected.)
1: The control panel of the copier becomes nondisplay mode
(When the control panel-mounted external controller is connected.)
BASE-SW Use it when trouble attributable to MEAP application occurs. By setting to '0', the operation of MEAP
application can be controlled.
settings
0: off (base model); 1: on (full model) [Default]
MEMO:
The change only from '1' to '0' is possible.
SC-L-CNT Switch settings for paper size Large/ Small threshold in scanner counter
Sets whether to count B4 size are Large or Small.
Setting range
0: B4 size is counted as Small size paper.
1: B4 size is counted as Large size paper.
Reference value
0
Note
If 1 is set, so that B4 size is counted as large size paper, LTR size will be counted as Small size paper.
REPORT-Z Report print attribute flag function control
Switches attribute flags added to report prints.
Setting values
0: PDL text mode
1: PDL photograph mode
2: SCAN text mode
3: SCAN photograph mode
[Factory settings and after RAM clear: 0]
COPIER>OPTION>BODY
Chapter 19
1
1
1
1
1
1
1
1
19-77