Canon imagerunner C5180 Service Manual page 743

Chapter 19
FREG-SW Switching display/nondisplay of a free register area of SEND MEAP counter
Settings
0: Nondisplay [Factory default/After RAM clear]
1: Display
MEMO:
- This is not used at normal servicing because it is for trouble analysis.
- Obey the instruction by the quality support section for usage.
IFAX-SZL Switching transmission size limitation during IFAX transmission (Only when bypassing
server)
Settings
0: Transmission size limitation is enabled (via/bypassing server)
1: Transmission size limitation is disabled (bypassing server only)
[Factory default/After RAM clear]
In the case of setting '0',
- as for upper limit value, set it in transmission data size by selecting the following:
additional functions mode>System Settings>Communications Settings>E-mail/I-Fax
Settings>Maximum Data Size For Setting
- if sending data that the size exceeds the upper limit value, it will be #830 error.
IFAX-PGD Permitting the divided transmission per page (only when the upper limit of the transmission
data size is exceeded).
Settings
0: Not permit the divided transmission per page upon transmission in the IFAX Simple mode.
[Factory default/After RAM clear]
1: Permits the divided transmission per page upon transmission in the IFAX Simple mode.
When setting '1', in the case of exporting the address book data from remote UI, the password
of file server is hidden from the exported file (to avoid leakage of information).
MEAPSAFE Switching over to the MEAP safe mode.
Settings
0: Normal mode [Factory default/After RAM clear]
1: Safe mode
Safe mode works to stop the added MEAP application, and to startup the only system
application that was activated at initial state to start up the system safely.
Set '1' to startup in safe mode in the case of system recovery processing when MEAP platform
does not startup normally because of resource competition among MEAP applications, or the
order to register/use the service.
"MPSF" is indicated in the control panel screen when in safe mode.
TRAY-FLL Setting the timing to issue an output-tray-full warning.
Settings
0: Issues an output-tray-full warning when all the delivery trays become full.
[Factory default/After RAM clear]
1: Issues an output-tray-full warning when all the specified trays become full.
PRNT-POS Toggle switch to pause or not pause all subsequent print jobs once a job has been cancelled
because of an error
In DL printing, sets whether to pause all print jobs once a job has been cancelled for a machine
error other than a service call (#037, etc.).
Setting values
0: No pause
1: Pause all jobs
[Factory settings and after RAM clear: 0]
AFN-PSWD Limiting access to the User Mode.
Settings
0: Normal mode (Enters the User Mode without asking a password)
[Factory default/After RAM clear]
1: Enters the User Mode after a password matches.
19-98
COPIER>OPTION>USER
Specification selection related to user mode
2
2
2
2
2
2
2