Canon imagerunner C5180 Service Manual page 717

Chapter 19
Sub item
FEED-CHK Use it to check paper movement in the ADF on its own.
Operation
1) Press [FEED-CHK] to highlight.
2) Enter the number of the component using the keypad.
3) Press the OK key.
4) Press [FEED-ON] to start checking the operation.
Feed Mode
0: single-sided operation
1: double-side operation
2: single-sided operation w/ stamp
3: double-sided operation w/ stamp
[Factory default/After RAM clear: 0]
CL-CHK Use it to check the DF fan on its own.
0:DF fan
Method of Operation
1)Press [FAN-CHK] (to highlight).
2)Enter the code of the part you want to check using the keypad.
3)Press the OK key.
4)Press [FAN-ON] to start checking the operation.
CL-ON Use it to start the operation of the selected clutch.
Press [CL-ON] and then press the OK key to start the operation of the clutch.
Another press on the key will stop the operation.
(The operation will stop in 200 msec; however, unless you press the OK key once again, the
indication will not change to 'STOP.)
FAN-CHK Use it to check the DF cooling fan.
Perform using FAN-ON.
1) Press [FAN-CHK] to highlight.
2) Enter the number of the component using the keypad.
3) Press the OK key.
4) Press [FAN-ON] to start checking the operation.
Component Number
0: cooling fan
FAN-ON Use it to start the operation of the selected fan.
Method of Operation
Press [FAN-ON], and press the OK key to start the operation of the fan.
Another press on the OK key will stop the operation.
(The operation will automatically stop in 5 sec; hover, unless you press the OK key once again,
the indication will not turn 'STOP'.)
SL-CHK Use it to check the ADF solenoid on its own.
Operation
1) Press [SL-CHK] to highlight
2) Enter the number of the component using the keypad.
3) Press the OK key.
4) Press [SL-ON] to start checking the operation.
Number of Component
0: lock solenoid
1: stamp solenoid
[Factory default/After RAM clear: 0]
19-72
FEEDER>FUNCTION
Description level.
1
1
1
1
1
1