Canon imagerunner C5180 Service Manual page 709

Chapter 19
8. PART-CHK
Sub item
CL Used to specify clutch for operation check.
(Range: 1 to 10, 5 and above are reserved.)
Operation method
1) Select this item.
2) Enter the desired clutch code on the numeric keypad.
1: Two-sided registration clutch CL1
2: Two-sided paper feed clutch CL2
3: Conveyor clutch CL1 (paper deck)
4: Paper feed clutch CL2 (paper deck)
3) Press the OK key.
4) Press CL-ON, and check the operation.
CL-ON Used to start clutch operation check.
Operation method
1) Select this item, and press the OK key. The clutch turns ON/OFF in the pattern below.
0.5 second ON -> 10 seconds OFF -> 0.5 second ON -> 10 seconds OFF -> 0.5 second ON -> OFF
FAN Used to specify fan for operation check.
(Range: 1 to 10; 7 and above are reserved.)
Operation method
1) Select this item.
2) Enter the desired fan code on the numeric keypad.
1: Power cooling fan FM1
2: Fixing exhaust heat fan FM2
3: Copier exhaust heat fan FM3
4: Cleaner fan FM4
5: Paper delivery cooling fan FM5
6: Manual feed cooling fan FM6
3) Press the OK key.
4) Press FAN-ON, and check the operation.
FAN-ON Starts fan operation.
- Operation for power fan, fixing fan and cleaner fan:
1) Select this item, and press the OK key. The fan performs the operation below.
10 seconds ON at full-speed -> 10 seconds ON at half-speed -> Standby
- Operation for copier exhaust heat fan, paper delivery cooling fan and manual feed cooling fan:
1) Select this item, and press the OK key. The fan performs the operation below.
10 seconds ON at full-speed -> Standby
- Operation for controller fan:
1) Select this item, and press the OK key. The fan performs the operation below.
19-64
T-19-52
COPIER>FUNCTION>PART-CHK
Description level.
1
1
1
1