Drum Drive Unit - Canon imagerunner C5180 Service Manual

Chapter 9
Points to Note When Removing the Drum
ITB Motor Mounting
To remove, put your hand into the inside where you
have slid out the manual feed unit; then, while
holding down the swing plate [1] found to the rear of
the drum drive unit, remove from the machine's rear
side plate.
The drum drive unit is hooked on the protrusion from
the rear side plate; lift it slightly to remove.
F-9-53
15) Remove the drum ITB motor base [3].
- 2 connectors [1]
- 3 screws [2]
[2]
[1]
[2]
[1]
F-9-54
9-56
16) Remove the developing drive unit [4].
- 6 wire saddles [1]
- 1 connector [2]
- 7 screws [3]
[2]
[1]
[3]
[1]
[1]
[4]
9.9.2.2 Removing the Drum Drive Unit
1) Remove the drum drive unit [3].
- 6 connectors [1]
- 7 screws [2]
[2]
[3]
[1]
[2]
[2]
[3]
[3]
F-9-55
[1] [2]
[1]
[2] [3] [2]
F-9-56
[2]
[2]