Table of Contents
Advertisement
Chapter 16
used for group control, enter '1')
2) Turn off and then on the machine; when the
machine has started up, perform the following in
user mode:
Select the following : user mode >system control
settings >group ID control >count control; then,
check that IDs from 00000001 through 00001000
have been prepared.
Select the following : user mode >system control
settings >network settings >TCP/IP settings >IP
address; then, set up 'IP address' 'gateway address'
and 'subnet mask'
Select the following : user mode >system
administrator setup; then, fill in 'system control
group ID' and 'system control ID No.' thereafter,
turn off and then on the machine.
If you leave out 'system control group ID' and
'system control ID No.' the service engineer will
not be able to 'register card to device' as part of
setup work for NSA.
3) With the machine in standby state, download the
card ID to be used from NSA.
4) When the card data has been downloaded from
NSA, check that the ID data has correctly been
downloaded on the screen brought up by making
the following selections:
user mode>system control settings>group ID
control
(Only the downloaded ID data must be indicated.)
5) Make copies using a user card registered with
NSA, and check that statistical operations are
made for the device in question.
16.6.6 When Replacing the Power
Supply PCB
There is no particular work to perform after
replacing the power supply PCB.
16-16
16.7 Pickup/Feeding System
16.7.1 Adjusting the Horizontal
Registration When Replacing the
Pickup Cassette
Make a test copy of the A3 Test Chart, and check that
the margin on the front side of the image is correct
(L2 = 2.0 ±1.5 mm); otherwise, go through the
following steps to adjust, starting with the 1st side
and then the 2nd side:
1. Adjusting the Horizontal Registration on the
1st Side
1) Slide out the manual feed unit and the cassette 1/
2; then, open the pickup vertical path cover.
2) Remove the 2 screws [1], and remove the front
right cover [2].
F-16-40
- Adjusting the Cassette 1 Side
3) Insert a screwdriver through the hole in the front
right stay, and loosen the screw [1] to adjust the
position of the adjusting plate [2].
F-16-41
Advertisement
Chapters
Table of Contents
