Table of Contents
Advertisement
Chapter 19
IFXEML-Z
Colour iFAX, E-Mail Rx print attribute flag function control
Switches attribute flags added to colour iFAX, E-Mail Rx prints.
Setting values
0: PDL text mode
1: PDL photograph mode
2: SCAN text mode
4: SCAN photograph mode
[Factory settings and after RAM clear: 0]
BMLNKS-Z BMLinks Rx print attribute flag function control
Switches attribute flags added to colour BMLinks Rx prints.
Setting values
0: SCAN photograph mode
1: PDL photograph mode
2: SCAN text mode
3: PDL text mode
[Factory settings and after RAM clear: 0]
DELV-THY Switch toner ejection threshold value
Sets threshold value of mean image ratio for forced toner ejection sequence.
Setting range: 1 to 5(%)
[Factory settings and after RAM clear: 2]
SCANSLCT Used to turn ON/OFF function that calculates scan area from selected paper size.
settings
0: AB; 1: inch
(Factory default value: varies by destinations / value after RAM clear: 0)
Due to the reader controller PCB RAM clear, the value is set as '0'. Re-define the value as '1' for inch-
configuration destination machines (North America etc.,)
When setting as '1', if the media size is larger than the original size, productivity decreases due to a
larger scanning area.
SENS-CNF Use it to set the original sensor.
Settings
0: AB configuration
1: inch configuration
[Factory default/After RAM clear: 0]
RAW-
Sets whether to print out raw received data.
DATA
0: Normal operation [Factory default/After RAM clear]
1: Print out raw received data
RMT-
Used to select language of remote UI used from Web.
LANG
Select language code with + and - keys.
IFAX-LIM
Used to select whether number of output lines will be restricted when largevolume data is received by
IFAX.
0: No restriction
1 to 999 [Factory default/After RAM clear: 500]
TC-REF
Used to turn ON/OFF environmental compensation on ATR sensor output
Normally, the ATR sensor output value used is the value compensated for the environment.
0: Environmental compensation OFF
1: Environmental compensation ON [Factory default/After RAM clear]
If fogging occurs in a low-humidity environment, set this item to 0.
SMTPTXP
Used to change SMTP send port number.
N
0 to 65535 (increments of 1) [Factory default/After RAM clear: 25]
SMTPRXP
Used to change SMTP receive port number.
N
0 to 65535 (increments of 1) [Factory default/After RAM clear: 25]
POP3PN
Used to change POP receive port number.
0 to 65535 (increments of 1) [Factory default/After RAM clear: 110]
19-78
COPIER>OPTION>BODY
1
1
1
2
2
2
2
2
2
2
2
2
Advertisement
Chapters
Table of Contents
