Drum Drive Unit; Drum Itb Motor - Canon imagerunner C5180 Service Manual

9.9.1.2 Removing the Drum ITB Motor
1) Remove the drum ITB motor [2].
- 4 screws [1]
F-9-50

9.9.2 Drum Drive Unit

9.9.2.1 Preparation for Removing the
Drum Drive Unit
1) Open the front cover and pull out the drum
unit.(page 12-20)Reference[Removing the Front
Cover]
2) Remove the rear fan cover.(page
22)Reference[Removing the Rear Fan Cover]
3) emove the upper rear cover.(page
22)Reference[Removing the Rear Upper Cover]
4) Remove the lower rear cover.(page 12-
23)Reference[Removing the Rear Lower Cover]
5) Remove the rear left cover (upper).(page 12-
21)Reference[Removing the Left Rear Cover
(Upper)]
6) Remove the left rear cover (upper).(page 12-
23)Reference[Removing the Rear Left Cover
(Upper)]
7) Remove the main controller cover.(page 5-
23)Reference[Removing the Main Controller
Box]
8) Remove the DC controller box 2.(page 12-
31)Reference[Removing the DC Controller
Box2]
9) Remove the DC controller box 1.(page 12-
32)Reference[Removing the DC Controller
Box1]
10) Remove the IH power supply unit.(page 12-
29)Reference[Removing the IH Power Supply
Unit]
11) Remove the high-voltage unit 1.(page 12-
27)Reference[Removing
Unit1]
12-
12-
the High-Voltage
12) Remove the mount [3].
- 19 connectors
- 7 clamps [1]
- 4 screws [2]
[1]
[2]
F-9-51
13) Remove the lattice connector mount [4].
- 2 clamps [1]
- 2 screws [2]
- 6 connectors [3]
[2]
[4]
[1]
F-9-52
14) Remove the high-voltage unit 2.(page 12-
28)Reference[Removing the High-Voltage Unit
2]
Chapter 9
[2] [3]
[1]
[3]
[3]
[3]
[3]
[3]
[2]
9-55
[1]
[2]