Table of Contents
Advertisement
Sub item
CNT-MCON
Clears service counters maintained by main controller PCB (main).
(See the COUNTER mode items for the counters cleared.)
The counter values are cleared after the main power switch is turned OFF/ON.
Operation method
1) Select this item, then press the OK key.
2) Turn the main power OFF/ON.
CNT-DCON
Clears following service counters maintained by DC controller PCB:
- COPIER>COUNTER>DRBL-2>SORT
- COPIER>COUNTER>DRBL-2>FIN-STPR
- COPIER>COUNTER>DRBL-2>FIN-PDDL
- COPIER>COUNTER>DRBL-2>SADDLE
- COPIER>COUNTER>DRBL-2>SDL-STPL
The counter values are cleared after the main power switch is turned OFF/ON.
Operation method
1) Select this item, then press the OK key.
2) Turn the main power OFF/ON.
OPTION
Restores OPTION service mode setting values to default values (RAM clear values).
The setting values are cleared after the main power switch is turned OFF/ON.
Note The cleared data is the data in the main controller, DC controller and reader controller.
Operation method
1) Select COPIER > FUNCTION > MISC-P > P-PRINT to print out the service mode setting
values.
2) Select this item, then press the OK key.
3) Turn the main power OFF/ON.
MMI
Clears following user mode setting values:
- Backup data for copy operation panel (user-set values)
- Common settings backup data (user-set values)
- Backup data (except fax data) (user-set values)
The setting values are cleared after the main power switch is turned OFF/ON.
Operation method
1) Select this item, then press the OK key.
2) Turn the main power OFF/ON.
MN-CON
Clears RAM on main controller PCB's SRAM board.
- The RAM is cleared after the OK key is pressed.
- Performing this item initializes all the data on the SRAM board. In other words, file
management information for the hard disk is initialized, and image data on the hard disk can no
longer be read. Before performing this item, explain to the user that all images in the BOX will
be lost, and receive permission to perform.
Operation method
1) Select COPIER > FUNCTION > MISC-P > P-PRINT to print out the service mode setting
values.
2) Select this item, then press the OK key.
CARD
Clears card ID (department) data.
The card ID data is cleared after the main power switch is turned OFF/ON.
Operation method
1) Select this item, then press the OK key.
2) Turn the main power OFF/ON.
COPIER>FUNCTION>CLEAR
Description
Chapter 19
level.
1
1
1
1
1
1
19-67
Advertisement
Chapters
Table of Contents
