Canon imagerunner C5180 Service Manual page 739

Chapter 19
COPY-JOB Prohibits copy job reservations when card reader and coin vendor are in use.
Setting values
0: Copy job reservations [Factory default/After RAM clear]
1: No copy job reservations
TAB-ROT Rotates landscape images on PDL tab paper 180 degrees.
Setting values
0: Don't rotate [Factory default/After RAM clear]
1: Rotate
PR-PSESW Print pause function switch display selection
Sets whether to display the print pause switch on the user screen.
Setting values
0: No display
1: Display
[Factory settings and after RAM clear: 0]
IDPRN-SW Used to switch type of count-up job for department management counter.
Setting values
0: BoxPrint, ReportPrint, SendLocalPrint and PDLPrint are counted as PRINT categories
[Factory default/After RAM clear]
1: Only PDLPrint is counted as a PRINT category
CPRT-DSP Used to select whether to display count print button in sales counter check screen, for Lawson
models.
Setting values
0: Don't display (This setting is only for stores that request it.)
1: Display (Count print function can be used.)
[Factory default/After RAM clear]
CNT-SW use it to select charge counters and default display items (100-V model only)
Settings
0: counter 1-101 total 1
counter 2-108 total (black-and-white 1)
counter 3-232 copy (full color + mono color/1)
counter 3-234 copy (full color + mono color/1)
1: counter 1-101 total 2
counter 2-231 copy (full color + mono color/2)
counter 3-148 total A (full color + mono color/2)
counter 4-222 copy (black-and-white 2)
counter 5-133 total A (black-and-white 2)
[Factory default/After RAM clear]
BCNT-AST Used to select a job type with which to count BOX print from ASSIST.
Setting values
0: Count as PDL print [Factory default/After RAM clear]
1: Count as Copy print
DFLT-CPY Sets default COPY colour mode.
Setting values
0: AUTO/ACS/Driver setting
1: Full colour
2: Black and white
JPN [Factory settings and after RAM clear: 0]
USA [Factory settings and after RAM clear: 0]
EUR [Factory settings and after RAM clear: 2 (CLC models: 0)]
Other than the above: [Factory settings and after RAM clear: 2]
19-94
COPIER>OPTION>USER
Specification selection related to user mode
1
1
1
1
1
1
1
1