Canon imagerunner C5180 Service Manual page 635

Displayed Detection timing
code
8001 When the side registration fails to
leave the side registration home
position sensor position even when
the punch slide unit is moved 9 mm
during the initial operation of the
side registration motor
8002 When the side registration fails to
return to the side registration home
position sensor position even when
the punch slide unit is moved 37
mm during the initial operation of
the side registration motor
E5F0 Saddle sheet positioning error
8001 When the sheet positioning plate
home position sensor fails to turn
ON even when the sheet
positioning plate motor is driven by
1500 pulses
8002 When the sheet positioning plate
home position sensor fails to turn
OFF even when the sheet
positioning plate motor is driven by
300 pulses
E5F1 Saddle sheet creasing error
8001 When the number of detection
pulses of the sheet creasing motor
clock sensor has dropped below the
prescribed number
8002 When the sheet creasing home
position sensor status fails to
change even when the sheet
creasing motor is driven for 3 sec.
E5F2 Saddle guide error
8001 When the guide home position
sensor fails to turn ON even when
the guide motor is driven by 700
pulses
8002 When the guide home position
sensor fails to turn OFF even when
the guide motor is driven by 1 sec.
E5F3 Saddle alignment error
8001 When the alignment plate home
position sensor fails to turn ON
even when the alignment motor is
driven for 0.5 sec. (or driven for
1.67 sec. during the initial
operation)
8002 When the alignment plate home
position sensor fails to turn OFF
even when the alignment motor is
driven for 1 sec.
E5F4 Saddle rear stapler error
Remedial action
- Check the side registration home position sensor (P161) connectors.
- Replace the side registration home position sensor (P161).
- Replace the side registration motor (M62).
- Check the sheet positioning plate home position sensor (P17) connectors.
- Replace the sheet positioning plate home position sensor (P17).
- Replace the sheet positioning plate motor (M4).
- Check the sheet creasing motor clock sensor (P14) and sheet creasing
home position sensor (P121) connectors.
- Replace the sheet creasing motor clock sensor (P14) and sheet creasing
home position sensor (P121).
- Replace the sheet creasing motor (M2).
When the sheet creasing home position sensor status fails to change even
when the sheet creasing motor is driven for 3 sec.
- Check the guide home position sensor (P113) connectors.
- Replace the guide home position sensor (P113).
- Replace the guide motor (M3).
- Check the alignment plate home position sensor (P15S) connectors.
- Replace the alignment plate home position sensor (P15S).
- Replace the alignment motor (M5S).
Chapter 18
18-17