Canon imagerunner C5180 Service Manual page 208

6.4.12.4 Adjusting the Position of the No.
1/No. 2 Mirror Base
1) Set the pins at the rear of the mirror positioning
tool (FY9-3009-040) in such a way so that the tool
may be used for the machine.
[C]
[A]
F-6-92
2) Set the pins at the front of the mirror positioning
tool in such a way so that the tool may be used for
the machine.
[B]
[A]
[B]
F-6-93
[B]
[A]
[B]
[C]
[A]
3) Insert the pins of the mirror positioning tool (front
[2]; rear [3]) of the mirror positioning tool into the
holes [1] of the No. 1 mirror base, No. 2 mirror
base, and rail.
[1]
F-6-94
[1]
F-6-95
4) Fix the trailing rear edge of the wire, which was
temporarily tightened to the hook of the reader
flame, with the screw.
5) Tighten the screws of front/rear side of the wire
fixing plate.
6) Remove the mirror positioning tool (front, rear).
7) Put back the parts by reversing the steps used to
remove them
Chapter 6
[2]
[3]
6-41