Canon imagerunner C5180 Service Manual page 632

Chapter 18
Displayed Detection timing
code
8001 - When the tray fails to return to the
home position even when the 2nd
tray shift motor has been driven for
20 sec.
- When the tray fails to move to
another area even when the 2nd tray
shift motor has been driven for 4
sec.
8002 - When the upper limit area is
reached before the sheet level is
detected by the 2nd tray sheet level
detection sensor 1 during a sheet
level detection operation
- When a discontinuous area was
detected during the tray operation
- When the fact that the area ahead
of the 2nd tray sheet level detection
sensor 2 has been reached is
detected before the sheet level is
detected by the 2nd tray sheet level
detection sensor 2 during an escape
operation
8004 When the input of the clock signal
could not be detected within 0.2
sec. while the 2nd tray shift motor
was running
8005 When the lock detection signal was
set to OFF 150 ms after the lock
detection signal was set to ON
8006 When the lock detection signal
could not be set to ON within 1 sec.
after the 2nd tray shift motor started
driving
8007 When the lock detection signal fails
to go OFF when the 2nd tray shift
motor is stopped
E575
0001 When the binding motor was driven
for 2000 ms in the binding direction
(HP sensor approach direction)
during a binding motor operation
but the binding HP sensor failed to
turn ON
0002 When the binding motor was driven
for 2000 ms in the HP sensor escape
direction during a binding motor
operation but the binding HP sensor
failed to turn OFF
E584 Tray unit trouble
0001 - When the tray safety switch is
actuated during a tray operation (up
or down)
- When the tray was operated with
the finger pinching prevention
switch actuated
18-14
Remedial action
- Check the 2nd tray shift area sensor board connectors.
- Replace the 2nd tray shift area sensor board.
- Replace the 2nd tray shift motor (M108).
- Check the binding HP sensor connectors.
- Check the binding motor connectors.
- Check the binding HP sensor connectors.
- Replace the binding motor.
- Replace the finisher controller PCB.
- Check the tray shift motor connectors.
- Check the tray safety switch connectors.
- Replace the tray shift motor.
- Replace the finisher controller PCB.