Canon imagerunner C5180 Service Manual page 687

Chapter 19
Sub item
50-GB Use it to indicate the degree of offset (color displacement; GB) for book mode at 50% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
100-RG Use it to indicate the degree of offset (color displacement; RG) for book mode at 100% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
100-GB Use it to indicate the degree of offset (color displacement; GB) for book mode at 100% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
50DF-RG Use it to indicate the degree of offset (color displacement RG) for ADF mode at 50% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
50DF-GB Use it to indicate the degree of offset (color displacement; GB) for ADF mode at 50% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
100DF-RG Use it to indicate the degree of offset (color displacement; RG) for ADF mode at 100% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
100DF-GB Use it to indicate the degree of offset (color displacement; GB) for ADF mode at 100% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
19-42
COPIER>ADJUST>CCD
Description level.
1
1
1
1
1
1
1