Table of Contents
Advertisement
Chapter 9
Be sure to fix the connecting plate (rear) with screws
while pressing the transfer frame in the direction
shown by the arrows.
F-9-81
5) Fit the boss [1] on the frame at the rear into the
recess [A] in the middle right cover so that the unit
is upright.
[1]
[A]
F-9-82
9-64
6) Be sure that the rear link plate [1] is on the
opposite of the middle right cover so that the
intermediate transfer unit will not fall down.
F-9-83
7) Remove the 4 screws at the rear [1], and pull out
the link plate (front) [2]; then, rotate it 180 deg.
[1]
[2]
F-9-84
Be sure to fix the connecting plate (front) with
screws while pressing the transfer frame in the
direction shown by the arrows.
[1]
[B]
[A]
[1]
Advertisement
Chapters
Table of Contents
