Chapter 2
2.2 Unpacking and Installation
2.2.1 Points to Note About Relocating
the machine
Points to Note About Relocating the machine
Be sure not to push the machine strongly from the
front side, otherwise it can fall over. (Especially in
the case of the carpet floor.)
2.2.2 Mounting the Reader Unit (Color
Image Reader E1/F1)
Working as a group of 4, hold the 4 grips (left, right),
and lift the machine off the skid [1].
The machine weighs about 130 kg. Be sure to work
as a group of 4. Also, lift the main body while
keeping it level.
Install two-cassette pedestal and plane pedestal as in
the following order.
1. Two-cassette pedestal and plane pedestal
(including mounting the body on pedestal).
2. Reader
3. Main body
2-8
F-2-7
The Color Image Reader F1and the Color Image
Reader E1 may be installed in the same way. The
illustrations that follow are of the Color Image
Reader F1.
1) Unpack and take the reader unit out of its shipping
box.
2) Remove al tape from the reader unit and the
machine.
3) Shift the reader unit [1] to the left as shown, and
place it on the machine [2].
[1]
100 mm or more
4) Using a screwdriver, fit the 2 reader unit
positioning pins [1] to the reader unit [2].
[2]
[1]
F-2-8
F-2-9
[2]